Flooring across Hot Springs and the Village
Flooring Installation in Hot Springs and Hot Springs Village
The old floor comes up, we check the subfloor under it for soft spots, and the new floor goes down. Every finished floor is level from wall to wall with the baseboard tight against it.
The work
Floors we install
Flat is the whole standard on a floor. LVP and LVT need a rigid base under them, and tile and hardwood need the same. The baseboard then closes tight against the new material with no gap at the wall.
Under the material is the part nobody sees. Plywood or AdvanTech that has gone soft comes out, and new sheeting goes back in flat. Tile that is still stuck down tight stays put and takes fresh grout.
One call handles your entire project from start to finish. Ask for a free estimate and we come look at the floor, and that visit costs you nothing.
Before a plank goes down
Under the new floor
Our trained crew knows to look for the common problems in the early stages of a project. On a floor that means a subfloor gone soft near a plumbing line, or a base that was never flat in the first place. Catching both early is what keeps the finish flat later.
The order is the same on every floor. The baseboard and the old surface come up first. Soft subfloor comes out and new material goes in behind it. The new floor goes down over that, and the baseboard goes back on last.
The baseboard comes off anyway, so a new floor is the time to handle the drywall patching and the paint in the same room. At the doorway the new floor meets the casing, which is where a worn threshold or jamb is easiest to replace.
The material
What goes down
Tile you already own can stay and take new grout. Everything else comes up and goes back new.
LVP and LVT
Light oak LVP run wall to wall and under a built-in bench, over rosin paper laid across the subfloor first.
Tile floors
Tile set over a flat base, with clean grout in every joint and a bullnose edge where a floor steps down.
Subfloor replacement
Soft plywood or AdvanTech cut out and new sheets screwed down flat, so nothing under the finished floor moves.
Hardwood
Solid boards laid across the room over a subfloor that is flat and dry, with the baseboard set tight against them.
Finished floors
Bare subfloor to finished floor
A finished floor is level from wall to wall, and the baseboard meets it with no gap at the wall. The photos show each room before the old floor came up and after the new one went down.
Look at the finished floors beside every other room we have rebuilt.
BeforeAfter
BeforeAfter
BeforeAfterThe estimate
What moves the price
We measure the rooms and check what is under the old floor before anything goes on paper. The estimate lists the material and the work in front of it.
The square footage
How much floor you want covered, room by room.
What is under the floor
Whether the subfloor is still sound, and how much of it has to come out.
The material you pick
LVP and LVT, tile or hardwood, and each one lays differently.
The doorways
How many doorways the new floor has to pass through.
Straight answers
Questions we get asked
Can you lay LVP over the floor that is already down?
First we look at what is under the existing floor and how flat it is. Then we check whether your doors still clear a higher surface. The estimate says which route we would take.
Will the new floor run under my cabinets or stop at them?
That depends on the cabinet toe kick. One kitchen we floored has light oak LVP that goes under the sink cabinets and out through the doorway. We tell you at the estimate which way your kitchen goes.
Can you regrout my tile and leave it in place?
Yes. We cut the old grout out of the joints and clean them down. Fresh grout goes in, and the haze comes off the face of the tile before we leave.
What happens where the new floor meets the old one?
A wood transition strip cut to the opening goes in the doorway. It covers the height difference between the two floors, so nothing catches a toe at the threshold.
Where we work
Hot Springs and Garland County
Floors are a local job. Getting a moisture reading right in a Garland County crawlspace takes somebody who has opened one before, and the crew that lays the plank is the crew that checked the subfloor. Call 501-276-4770 and you get the same person who quoted it.
Neighbors around Hot Springs voted us a Nextdoor Neighborhood Favorite. That vote came from people who saw the floor after the last plank went down. We take the same drive out to Hot Springs Village and the Garland County towns around it.
Tell us about your floor
Get a free estimate
Tell us what you need and when. We call you back and set a time to look at the job.
